An alternative sprinkler head does not need to coincide brand name of the broken head. However, it does need to be the same type: impact or pop-up (stationary, rotor- or gear-driven rotor). And the new head also matches the gallons-per-minute (GPM) inches-per-hour (iph).
Distribution price of the old head. And also, the spray pattern and throwing distance must equally match. If the head is installed wrong, it can over-or underwater that section of your lawn or garden and cause various other heads because the same area underperforms. So you’ll require all the busted head specs before buying an alternative.
Check the nozzle, the head’s top (if it’s still there), or the label on the body of the head for that information (see ‘Remove the Broken Head’). If you can’t find the specs or part number, ask an irrigation service company for a matching replacement.
Table of Contents
Remove the broken head.
(Put a plastic sheet beside the broken sprinkler head. Then use a spade to cut an 8-in. circle around the old head. Pry out the turf as well as set it aside. Then, dig around the old head, allowing the dust to settle on the poly sheet. When you get to the water line, unscrew the damaged head.)
If the head lies at the low spot of a watering zone, possibilities are the hole will fill with water. And mud will certainly get into the water line. With your vacuum, suck the mud out. (The water line obtains flushed later.).
Set the new head height
Remove the old riser fitting from the old head and screw it onto the new one. After that, screw the brand-new head into the water line and test it out. Ensure that the top of the head is flush with the ground, not sticking out into the grass.
If it’s not the ideal height, grab a new poly cutoff riser with multiple threaded areas and cut it to the appropriate size. It may take a few shots (and a few risers) to obtain the elevation just right. Once you obtain the correct elevation, remove the head and purge the line utilizing the steps shown here.
Flush the water line with a flushing tool
Regardless of your carefulness, dirt will fall into the water line fitting. If your shop vacuum can’t remove all the dirt, flush it with a flushing tool with 3/4-in. Then flush the water line. Lastly, remove the flushing tool’s water by sucking it out.
Install the head and backfill
Into the freshly flushed water line, screw the new head and begin backfilling. As you tamp the dirt, align the head, so it sits straight in the hole. Replace the grass when you are done with the job. To reestablish the grassroots, water immediately.
Conlcusion
Hopefully I have answered all the queries regarding how to replace sprinkler heads firstly you need to remove broken head and then set a new head height and then flush the water line with a flushing tool at last install the head and backfill. Want to read reviews of some best sprinkler heads? No problem belogarden got you covered.